Rinnai INFINITY N-Series Instantaneous LPG/CNG Gas Water Heater

Rinnai INFINITY N-Series Gas Water Heater

$3,840.00
Tax included. Shipping calculated at checkout.
Gas
Location
PAYMENT OPTION:

The Rinnai INFINITY N-Series are condensing* gas continuous flow water heater designed for commercial applications and high hot water demand residential installations. The condensing technology uses a secondary heat exchanger to drive further thermal efficiency by extracting heat from combusted flue-gases. 

* Condensing technology utilises a secondary heat exchanger to drive further thermal efficiency by extracting heat from combusted flue gases, making the N-Series models 97% efficient.
  • Factory Pre-set temperature: 55C
  • Hot Water Capacity: 1.5-37L/Min 
  • Exhaust Type: 
    • External Unit: Forced Flue
    • Internal Unit: Room Sealed Forced Flue
  • Frost Protection: Fitted as standard. Frost protection operates automatically, as long as the unit is connected to the power supply. Frost protection activates when the temperature inside the unit drops below 3.5C and turns off once the temperature reaches 7C.
  • Ignition System: Direct electronic ignition
  • Line Pressure Min-Max (LPG): 2.75 - 3.5kPa
  • Line Pressure Min-Max (NG): 1.13 - 3.5kPa
  • Power Consumption:
    • Standby: 2.4W
    • NG: 70W
    • LPG: 85W
    • Frost Protection (External): 154W
    • Frost Protection (Internal): 150W
  • Water Supply: Nominal Operating Pressure 300-1000kPa
  • Noise Level:
    • Internal: 49dB(A)
    • External: 54dB(A)
  • Safety Devices: 
    • Flame failure 
    • Boil dry protection
    • Overheat protection
    • Fusible link
    • Pressure relief valve
    • Combustion fan RPM check
  • Dimensions:
    • Internal: H670 x W470 x D276mm
    • External: H670 x W470 xD276mm
  • Weight: 29kg
  • Full Stainless Steel heat exchanger and internal piping
  • Inverted Burner means longer service intervals 
  • Inbuilt control panel
  • Pump connectivity, the N-Series can power and control a circulating ring main
  • Inbuilt temperature sensor, unit can run in-series with a circulating ring main
  • Pre-mix burner, no gas pressure setting required means very easy gas type conversion
  • Daisy chain electronic connection, very simple (and low cost) electronic connections
  • Powerful fan allows a lower cost common flue to be installed

Please Note: If the inlet pressure or flow rate drops below the minimum values stated above, operation of the INFINITY is not guaranteed. The unit requires both minimum flow rate and pressure to operate correctly.

Warranty: Heat Exchanger 12 years, all other parts 5 years

  • 100% KIWI OWNED AND OPERATED
  • LOCAL KNOWLEDGE AND EXPERTISE
  • SAVE BIG ON FUEL WITH AA SMART FUEL REWARDS

Recently viewed